System Board - HP Folio 13-2000 Maintenance And Service Manual

System board

NOTE: The system board spare part kit includes replacement thermal material.
Description
For use only with computer models equipped with an Intel 1.6 GHz processor, but not WWAN
capability (includes replacement thermal material)
Before removing the system board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the base enclosure screws (see
5. Remove the keyboard (see
6. Remove the top cover (see
7. Remove the battery (see
8. Remove the WLAN module (see
9. Remove the hard drive (see
10. Disconnect the display panel cable from the system board (see
11. Remove the speakers (see
12. Remove the power connector cable (see
13. Remove the USB/Audio cable (see USB/Audio).
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
●
RTC battery (see
●
Memory module (see
●
Power connector cable (see
●
Fan (see
●
Heat sink (see
●
WLAN module see
●
Hard drive (see
●
USB/Audio (see USB/Audio)
●
Display panel cable (see
Keyboard on page
Top cover on page
Battery on page
Hard drive on page
Speakers on page
RTC battery on page
Memory module on page
Power connector cable on page
Fan/Heat sink on page
Fan/Heat sink on page
(WLAN module on page
Hard drive on page
Display panel on page
Base enclosure on page
26),
28).
32).
WLAN module on page
40).
42).
Power connector cable on page
39)
41)
46)
46)
36).
40).
34).
Spare part number
682564-001
25).
36).
Display panel on page
44).
44)
Component replacement procedures
34).
43