Emotiva XPR-2 User Manual page 22

Problem: No sound is heard; the Standby LED is flashing red and one or
both rows of Channel Status and LED Bargraph Meter LEDs are flashing
red.
Reason: The XPR-2 is in Protect mode, which indicates a Fault condition.
• Switch the AC Power switch Off and On to clear the Fault condition.
• If the fault remains, look for a shorted speaker cable or damaged speaker.
• Check your sources and source connections (a bad interconnect, DC on the input,
or an otherwise bad source component can cause a fault).
Problem: The Standby LED is red and the XPR-2 fails to come on when
triggered.
Reason: The XPR-2 is in Standby mode and should respond to a valid trigger signal.
• Check your trigger cable.
• Check the trigger settings on your source equipment.
XPR-2
Page 19