First Time Use - Hitachi 42HDS52 Operating Manual

Accessories
Check to make sure you have the following accessories before disposing of the packing material.
Remote Control
CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
2. This stand for use only with Hitachi 42HDS52 and 42HDS52A. Use with other
Remote Control Unit CLU-3852WL
(Part No. HL02066).
Two "AA" size, 1.5V batteries (P# FQ00021).
Power Cord (P# EV01841).
Two IR Mouse cables (P# EY01641).
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1. Open the battery cover of the remote control by pushing down and
sliding the back cover off.
2. Insert two new "AA" size batteries for the remote control. When
replacing old batteries, push them towards the springs and lift them
out.
3. Match the batteries to the (+) and (-) marks in the battery
compartment.
4. Replace the cover.
CAUTION: Do not insert batteries with '+' and '-' polarities reversed as this may cause the batteries
to swell or rupture resulting in leakage.
4
Two "AA" size,
1.5V batteries
Power Cord
2 IR Mouse Cable
provide adequate ventilation for the electronics or proper support for the front glass
panel. This plasma television product is designed for a maximum tilting angle of 45
degrees from vertical.
apparatus is capable of resulting in instability causing possible injury. See
important marking located on bottom of stand.
Table Top Stand
(42" models only)
Cleaning Cloth
Power Swivel Cable
(42" models only)
Table Top Stand (P# QJ01831K).
Cleaning Cloth (P# MS00931).
Power Swivel Cable (P# EW08431).
Ferrite Core (P# 2169513).
BOTTOM VIEW
(Remote Control)
Press down and slide back to remove.
1 Ferrite Core
(see page 13)
Note: Please visit our
website for optional
accessories for the
55" models.
For U.S. models:
For optional
accessories, please
access our web site at:
www.hitachi.us/tv