First Time Use; The Remote Control - Hitachi P50S601 Operating Manual

Accessories
Check to make sure you have the following accessories before disposing of the packing material.
³
Remote Control
For U.S. models: For optional accessories, please access our web site at: www.hitachi.us/tv
CANADA only: For optional accessories, please access our web site at: www.hitachi.ca/tv
CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
2. This stand for use only with Hitachi P50S601. Use with other apparatus is
3. The wall mount unit for the 50" models is WM07S. Please see page 7 for
³ Remote Control Unit CLU-4373A
(Part No. HL02403).
· Two "AA" size, 1.5V batteries.
» Power Swivel Table Top Stand
(Part No. QJ03754)
¿ Power Cord (Part No. EV01841).
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1. Open the battery cover of the remote control by pushing down and sliding the back cover off.
2. Insert two new "AA" size batteries for the remote control. When replacing old batteries, push them towards the
springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery
compartment.
4. Insert the bottom of the battery, the (-) side, into the battery
compartment first, push towards the springs and insert the
top of the battery, the (+) side, into place. Do not force the
battery into the battery compartment.
5. Replace the cover.
CAUTION: Do not insert batteries with '+' and '-' polarities reversed as this may cause the batteries
to swell or rupture resulting in leakage.
4
·
Two "AA" size,
1.5V batteries
¿
Power Cord
provide adequate ventilation for the electronics or proper support for the front glass
panel. This plasma television product is designed for a maximum tilting angle of 45
degrees from vertical.
capable of resulting in instability causing possible injury.
important information related to the wall mount. Wall Mount unit is an optional
accessory (Not Included).
´ Power Swivel Cable (Part No. EW08433).
² Wire clamp
»
Power Swivel Table
Top Stand (included)
´ Power Swivel Cable
Bottom View (Remote Control)
Lift up on tab to remove back cover.
² Wire clamp