Hitachi 42HDS52 Operating Manual page 46

Channel Manager
Channel Manager
Select CHANNEL MANAGER to set your Antenna
options, run Auto Channel Scan, Check Signal Meter
and Set Channel List.
1. Press CURSOR PAD
highlight function
2. Press the SELECT button or CURSOR PAD
select.
Signal Meter
Select SIGNAL METER when using an indoor or outdoor
antenna. This feature will show the signal strength and
peak values of the Antenna signal to help you adjust your
antenna to optimize signal reception.
Use the CURSOR PADS and the SELECT button to
highlight and select CLOSE to exit.
NOTE: The Signal Meter will not be available (grayed
out) when watching analog channels.
Auto Channel Scan
This feature will automatically store active Analog and
Digital channels in Auto Channel Scan memory.
1. Use the CURSOR PAD
to highlight CABLE or AIR.
2. Press the CURSOR PAD
START or CLEAR option.
3. Press the SELECT button to start AUTO CHANNEL
SCAN.
NOTE: 1. When a CableCARD is installed, Auto
Channel Scan will not be available since
channels will be fixed based on what was
agreed upon by you and your cable
operator.
2. If certain channels are poor or not possible
in cable(1) mode, set cable source to cable(2)
by using the CURSOR buttons
46
, or CHANNEL WHEEL to
to
or or CHANNEL WHEEL
or to highlight the
or .
Video
Audio
Channel Manager
Locks
Timers
Setup
Power Swivel
Move Select
SEL
Channel Manager
Signal Meter
Auto Channel Scan
or
Channel List
Move Select
SEL
Channel Manager
Signal Meter
Auto Channel Scan
Channel List
Move Select
SEL
Channel Manager
Signal Meter
or
Channel 3-
Strength 1
Peak 1
Close
Move SEL Return
Channel Manager
Signal Meter
Auto Channel Scan
Channel List
Move Select
SEL
Channel Manager
Auto Channel Scan
or
Cable
Auto Channel Scan Start
Cable Source Cable(1)
Air
Auto Channel Scan Start
Move SEL Return
Reset
Reset