Appendixes - Hitachi 42HDS52 Operating Manual

Appendixes

Appendix E
After the CableCARD has been successfully installed, a
CableCARD Information menu appears in the SETUP
menu of the On-Screen Display.
Follow the instructions below to access the CableCARD
Information menu.
1. Press the MENU button on the Remote Control to
access the Main Menu screen.
Video
Audio
TV Guide On Screen
Channel Manager
Locks
Timers
Setup
Move Select
SEL
2. Use the CURSOR PAD
the Main Menu and press the SELECT button.
3. Use the CURSOR PAD
Information and press the SELECT button.
Setup
Menu Preference
Screen Saver
Set The Inputs
Set AV NET
Set Closed Captions
Set Monitor Out
CableCARD Information
Upgrades
Set Stand-By Mode
Move SEL Select
4. To view the CableCARD ID and Host ID, use the
CURSOR PAD to highlight CableCARD Info and
press the SELECT button.
Setup
CableCARD Information
Select the button below to acess
CableCARD ID and Host ID.
Select the button below to access
CableCARD and Host Diagnostics.
Move SEL Return
In order to start cable service
for this device, please contact
your cable provider
CableCARD(tm): 123-456-789-1
Host: 123-456-789-1
Data: 123-456-789-1
Unit Address: 123-456-789-1
Press EXIT to return
NOTE: The Diagnostics Info. window is for
Service use only.
THINGS TO CHECK WHEN USING THE
CableCARD / CableCARD Services
1. Check that the CableCARD is properly inserted in
2. Remove the CableCARD by pressing the eject
3. Visually inspect the CableCARD to ensure all pin-
4. Make sure the CableCARD is re-inserted in the
5. When the CableCARD is installed, note all screen
to highlight SETUP in
to highlight CableCARD
6. If problems still remain, please contact your Cable
NOTES:
CableCARD Info.
Diagnostics Info.
the CableCARD slot.
button and pull the CableCARD straight out.
holes are in good condition, with none blocked or
damaged.
correct direction, then slowly push until it is fully
seated in the slot.
messages that appear ("CableCARD Installed",
"Acquiring Data", "CableCARD is not Installed").
If the "CableCARD Installed" message does not
appear when card is installed, check the TV's card
slot and CableCARD pins for obstructions or
damage.
Service Provider.
1. When a CableCARD is installed, Auto
Channel scan will not be needed
because the channel list is automatically
loaded to the TV's channel memory.
2. The TV will take several seconds to
detect and recognize the presence of the
CableCARD. This process must be
completed before any CableCARD
information or Channel listings is
accessed.
81