Pppoe (Dsl) - D-Link DIR-685 User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router.
Address Mode: Select Static PPPoE if your ISP assigned you the IP address, subnet
mask, and gateway addresses. In most cases, select Dynamic
PPPoE.
User Name: Enter your PPPoE user name.
Password: Enter your PPPoE password and then retype the password in the
Confirm Password box.
Service Name: Enter the ISP Service Name (optional).
IP Address: Enter the IP address (Static PPPoE only).
MAC Address: The default MAC Address is set to the WAN/Internet port's
physical interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless
required by your ISP. You can use the Clone MAC Address button to
replace the WAN/Internet port's MAC address with the MAC address
of your Ethernet card.
DNS Address: Click the Receive DNS from ISP radio button to automatically obtain
the IP addresses of the DNS Servers for your Internet connection
from your ISP. Click the Enter DNS Manually radio button to enter the
DNS IP addresses manually. If choosing the manual option, enter the
IP addresses of the Primary and Secondary DNS servers supplied by
your ISP (Internet Service Provider) in the DNS Addresses textbox.
D-Link DIR-685 User Manual
Manual Internet Configuration

PPPoE (DSL)

38