Removing The Flail Screen - Troy-Bilt CSV 060 Operator's Manual

Removing the Flail Screen

If the discharge area becomes clogged, remove the flail screen
and clean area as follows:
1. Stop the engine. Make certain the chipper/shredder
vacuum has come to a complete stop.
2. Before unclogging the discharge chute, disconnect and
ground the spark plug wire to retaining post.
3. Remove the vacuum bag from the unit as instructed in the
OPERATION section to obtain access to flail screen.
4. Remove self tapping screw on right side of unit that
attaches to the flail screen. See Figure 6-2.
5. Remove hex screw on top of rear housing near mounting
bracket and the flange lock nut that secures flail screen.
See Figure 6-2.
6. Remove and clean the screen by scraping or washing with
water. See Figure 6-3.
7. Reinstall the screen.
14 S 6— M
ection aintenance
& a
djuStMentS
Figure 6-2
Figure 6-3