Check Before Riding; Set Up And Usage Instructions - Razor Spark Owner's Manual

SET UP aND USagE INSTRUCTIONS

q Replacing the Spark cartridge:
Friction during sparking will eventually wear out the replaceable cartridge and cause the scooter to stop making
sparks. Worn out cartridges must be replaced.
1
Using your thumbs, press tabs
on both sides of the cartridge to
release from the bracket. Slide car-
tridge away from you and remove
from bracket.
q Using the Spark bar
When riding, place ball of foot on the Spark bar and gradually apply pressure. Only use enough pressure to cause
sparking action.

CHECk BEFORE RIDINg

q Collar Clamp
Using a 5mm allen key, check that the collar clamp bolt is tightened securely. This item is tightened and quality
inspected at the factory, but there is a slight chance that the effects of shipping or handling may have caused this bolt
to become loose.
q Deck Plate/Steering Column adjusting Screw(s)
Using a 3mm allen wrench and with the scooter in the upright and locked position, adjust the set screw at the base-
board until there is no free-play between the baseboard and the steering column. Be careful not to over-tighten this
screw as it needs only be snug against the steering column. Verify the adjustment by releasing the steering column
from the locked position and folding the scooter. The locking lever should not bind and the folding movement should be
smooth when raising the handlebars. The spring-loaded mechanism should automatically lock and be fully seated in
the upright position.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service
centers at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific
Time.
2
Place a new cartridge in back of the bracket making sure to align the slots
on the cartridge with the two legs of the bracket and slide cartridge forward
until you hear a click and the thumb tabs are locked in place.
4
WaRNINg: Do not
attempt to replace cartridge
immediately after riding as
cartridge will be hot. Handle only
when cool.
WaRNINg: Keep fingers
clear of Spark Bar hinge and fender
brake.
WaRNINg: Applying
too much pressure on the Spark bar
may cause loss of control.
NOTE: Using any other part of
the foot or full foot may activate the
brake and prevent sparking action.
NOTE: Sparks and Spark
cartridge life will vary based on
the amount of pressure applied
to the spark bar, the length of
time pressure is applied and
the smoothness of the riding
surface.