Check Before Riding; Usage - Razor Spark Owner's Manual

CHeCk Before riDing

q Collar Clamp
Using a 5 mm Allen wrench, check that the collar clamp bolt is tightened securely. This item is tightened and quality
inspected at the factory, but there is a slight chance that the effects of shipping or handling may have caused this bolt
to become loose.
q Wheels and Bearings
Under normal circumstances and conditions, Razor wheels and bearings are maintenance free. Nonetheless, it is
the responsibility of the owner or guardian to periodically inspect the wheels for wear and tear, the axle for proper
tightness, and bearings for side-to-side play and loose parts. When a wheel or wheel bearing develops play, this is an
indication of excess wear and replacement is necessary. Replace immediately with only genuine Razor wheels. Wheels
other than genuine Razor wheels may not be compatible with your Razor scooter. The use of anything other than genu-
ine Razor replacement parts may affect your safety and will void your warranty.
q Cleaning your Scooter
Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they may damage the
surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may damage or dissolve the plastic
components or soften the decals or decal adhesive.

uSage

1
To stop, place the heel of the foot on the brake.
2
To activate the Sparks and LED lights on the deck,
place ball of foot on the Spark bar and gradually apply
pressure while riding. Only use enough pressure to
cause sparking action.
Note:
• LED deck lights apply to Spark 2.0 only.
• Lighted wheels light up when wheels are in motion.
(Spark 2.0 and Spark DLX only)
5
Warning: Wheelies
and other stunt-type riding reduces
your ability to maneuver and control
the scooter. Take the necessary
precautions, such as wearing
appropriate protective gear and
practice in an area safe for stunt
riding and free from obstructions.
note: Worn wheels, bearings
and Spark Cartridges are
considered normal wear-and-tear
and are not covered by the Razor
Warranty.
Warning: Applying too
much pressure on the Spark Bar
may cause loss of control.
note: Using any other part of
the foot or full foot may activate the
brake and prevent sparking action.
note: Sparks and Spark
Cartridge life will vary based on
the amount of pressure applied
to the Spark Bar, the length of
time pressure is applied and
the smoothness of the riding
surface.