Misfeed In The Upper Exit Area (When A Job Separator Tray Kit Or Finisher (Sg-Fn3) Is Installed); Misfeed In An Output Tray (When A Finisher (Sg-Fn3) Is Installed) - Sagem MF9300 Operation Manual

TROUBLESHOOTING AND MAINTENANCE
MISFEED IN THE UPPER EXIT AREA
(when a job separator tray kit or finisher (SG-FN3) is
installed)
If a job separator tray kit or a finisher is installed, a misfeed may occur in the upper exit area.
1
Open the upper right side cover.
2
Gently pull the misfed paper out.
MISFEED IN AN OUTPUT TRAY
(when a finisher (SG-FN3) is installed)
1
Grasp the handle of the stapler
compiler cover and pull to open the
cover.
70
Be careful not to tear the
misfed paper during
removal.
A MISFEED HAS OCCURRED.
INFORMATION
3
Close the upper right side cover.
Make sure that the misfeed message is cleared.
2
Remove any misfed paper from the
transport area.