Loading Paper In The Bypass Tray - Sagem MF9300 Operation Manual

BEFORE USING THE MACHINE

Loading paper in the bypass tray

1
Unfold the bypass tray.
2
Set the paper guides to the copy
paper width.
Important points when inserting paper in the bypass tray
• Be sure to place A6 size paper or envelopes in the
horizontal (landscape) orientation as shown in the
following diagram.
• Load the paper with the print side facing down.
• When loading envelopes, make sure that they are
straight and flat and do not have loosely glued
construction flaps (not the closure flap).
• When adding paper, first remove any paper
remaining in the bypass tray, combine it with the
paper to be added, and then reload as a single
stack. The paper to be added must be the same size
and type as the paper already in the bypass tray.
• Do not use paper that is smaller than the original
image. This may cause smudges or unclean images.
• Do not use paper that has already been printed on
by a laser printer or plain paper fax machine. This
may cause smudges or unclean images.
18
To enable correct
detection of the paper
size, be sure to pull out
the bypass tray
extension.
3
Insert the copy paper (print side
down) all the way into the bypass tray.