Safety Devices; Coffee Grinding; Coffee Dispensing; Pre-Ground Coffee - Saeco ROYAL SUP 016 E User's And Maintenance Booklet

95
coffee quantity, according to the cup dimension.
The desired quantity can be selected
through the selection keys . The relevant messages
will be displayed.
To set the quantity of coffee to be dispensed, it
is necessary to press the relevant selection key
till the desired quantity of coffee is obtained
(max. 250 ml approx.).
During this operation, the following message is
displayed:
"1 SMALL COFFEE "
"PROGR. QUANTITY "
The machine considers automatically the
necessary amounts to brew two cups of coffee.
Attention! If the pre-brewing function is enabled
during the cups dosage adjustment, keep the
selected key pressed even during the pump stop
until the desired amount is reached.
Double quantity of coffee or 2 cups of
coffee
By pressing one of the three selection keys twice,
before coffee dispensing begins, the machine
will brew a double portion of coffee.

Coffee grinding

34
This machine grinds a portion of fresh coffee for
each cup; for two cups, it grinds two portions of
coffee, one after the other, thus ensuring optimum
coffee quality.
Adjust the grinding degree according to the
instructions mentioned at page 90.
Adjust the grinding degree only when the coffee
grinder is running.
BREWING

Coffee dispensing

Place one or two preheated cups on the cupholder
grill (3) under the dispenser (6). By pressing the
relevant selection key, the machine will
automatically dispense the selected coffee.
Dispensing may be interrupted by pressing one
of the coffee selection keys, if an excessive water
amount has been selected. Should you interrupt
the coffee flow after the first of two coffees, the
second is not dispensed.

Pre-ground coffee

Make sure to use pre-ground coffee only (medium
ground). Never use whole beans or soluble
coffee.
Right before brewing coffee, fill the container
with freshly ground coffee. For best results, make
sure coffee blend is fresh.
Remember that ground coffee ages soon, thus
losing its quality!
35
Important!
Use the measuring spoon supplied to fill the
container (14) with a single portion of ground
coffee! Use a full measure only.
To dispense coffee, press pre-ground coffee button
and the desired selection key (large coffee,
coffee, small coffee) to obtain a cup of coffee.
Important! This function does not allow the
double coffee cycle.
Dispensing may be interrupted by pressing one
of the coffee selection keys, if an excessive water
amount has been selected.
96
Hot water dispensing
Hot water dispensing is accomplished through
an independent water circuit which ensures the
correct temperature and supplies tasteless hot
water to be used for tea, soup, etc.
Press the hot water key, the display will show:
"WATER DISPENSING "
During hot water dispensing, only the
programmed amount is dispensed if the
corresponding programming is enabled. On the
contrary, dispensing should be stopped by
pressing again the selection key when the desired
amount is reached.
To program the hot water amount, it is necessary
to keep the corresponding selection key pressed
till the desired amount is reached.
Attention: hot water can only be
programmed if the corresponding
programming function is enabled (see
page 87).
During the programming phase, the following
message will be displayed:
"HOT WATER "
"PROGR. QUANTITY "
36
Place a glass or cup under the steam/hot water
spout (7), then press the hot water selection key.
Hot water will be automatically dispensed.
Steam dispensing
To heat milk or other drinks.
Always clean the spout with a damp cloth soon

SAFETY DEVICES

after the use; otherwise, it might be difficult to
remove milk residues.
Turn the steam knob (9), the display will show:
"STEAM "
Direct steam/hot water spout (7) on cup holder
grill (3) and slightly open knob (9), turning it
counterclockwise.
Wait until the remaining water has flown out of
the spout. Then, move the spout outwards and
plunge it deeply into the fluid to be heated.
37
Slowly open the steam/hot water knob and heat
the fluid, with a circular movement from the
bottom to the top.
When the fluid has reached the desired tempe-
rature, close the knob and immediately clean the
spout with a damp cloth.
Attention: the spout is hot, it may cause burns!
Cappuccino
Through the special Cappuccinatore, this
machine can brew a real cappuccino without
any problem.
Press the Cappuccino key, the display will show:
"CAPPUCCINO "
INCORPORATED
SAFETY DEVICES
During the cappuccino dispensing, only the
programmed amount is dispensed if the
corresponding programming is enabled. On the
contrary, dispensing should be stopped by
pressing again the selection key when the desired
cappuccino amount has been reached.
To program the cappuccino amount, it is
necessary to keep the corresponding selection