Poulan Pro 330 Instruction Manual page 8

KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW, Compare the illustrations with your unit to familiarize yourself with the location of
the various controls and adjustments. Save this manual for future reference.
Front Handle
Bar Tool
Chain//_,_k& Front Hand Guard
Screw
Bar Oil
Fill Cap
Throttle Eo a st Idle
Lockout /_.
Rear _ _/_-
Handle _'_/
Throttle __
Trigger
Cylinder Cover
Chain Brake
_ ._/Starter Rope
Choke Knob
/ ON,STOR
_k/!_ _/.._j_-Switch
Starter Housing Fuel Mix Fill Cap
Guide Bar of Chain
Travel
Chain Brake Nuts
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine.
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed,
THROTTLE LOCK-OUT
The THROTTLE LOCK-OUT must be
pressed before you can squeeze the throttle
trigger. This feature prevents you from acci-
dentally squeezing the trigger.
FAST IDLE LOCK
The FAST iDLE LOCK hoids the throttle trig-
ger in the starting position. Activate the fast
idle lock by pressing the throttle lock-out and
squeezing the throttle trigger. With the
throttle trigger squeezed, press the fast idle
lock, Release the throttle lock-out and trig-
ger while holding the fast idle lock button.
CHOKE KNOB
The CHOKE KNOB activates the choke to
provide additional fuel to the engine during
cold starting.
CHAIN BRAKE
The CHAIN BRAKE is a device designed to
stop the chain if kickback occurs, The chain
brake activates automatically in the event of
kickback. The chain brake activates manu-
ally if the front hand guard is pushed forward.
The chain brake is disengaged by pulling the
front hand guard back toward the front han-
dle as far as possible,
CHAIN TENSION
It is nomqa_for a new chain to stretch during first
30 minutes of operation, You should check
your chain tension frequently, See CHAIN
TENSION under the ASSEMBLY section,
_, WARNING:
Muffler is very hotduring
and after use, Do not touch the muffler or at-
low combustible material such as dry grass
or fuel to do so.