Operation; Operating Procedure; Checking Operating Status; Operating Status Display Using Lcd Screen And Led Lamps - Mitsubishi Electric PV-S4200-IT Operating Manual

5 Operation

The following explains how to operate the PV inverter.

5.1 Operating Procedure

Operation panel
When setting to ON ( | )
Press
When setting to OFF ( )
Press

5.2 Checking Operating Status

The current operating status of the PV inverter is indicated on the display panel. All displays are unlit when irradiation is
low or during nighttime hours because the power supply of PV inverter is turned off.

5.2.1 Operating Status Display Using LCD Screen and LED lamps

A list of operating status displays is shown in the table below.
When stopped
LCD screen and LED lamps
The LED lamp
operating status is
indicated as shown
at right.
RUNNING
ITA:ENEL GUIDE
TOTAL
OUTPUT
MAXIMUM 4508W
DC disconnectors
Switch
Rubber
cover
ON state
When setting to ON, check
that the switch is set to the
horizontal position.
OFF state
: Lit
: Blinking
: Off
LCD screen
To start operation
Turn ON ( | ) the DC disconnectors at the
11358kWh
bottom of the PV inverter (DC1 and DC2).
4321W
The current operating status is displayed
on the display screen.
To stop operation
Turn OFF ( ) the DC disconnectors at the
bottom of the PV inverter (DC1 and DC2).
Description
During nighttime hours when there is no irradiation, or when
the DC disconnector at the bottom of the PV inverter is set
to OFF( ), the LCD screen and LED lamps are all unlit
because the power supply of PV inverter is turned off.
41
Procedure