Security Code Setup - Kenwood DDX8639 Instruction Manual

Security Code Setup

You can set a security code to protect your receiver
system against theft.
• When the Security Code function is activated it cannot be
released.
Note, your Security Code is the 4 digit number entered in
your "Car Audio Passport" in this package.
1
Display the Security Code Setup screen
Security
If
Security
touch
or
3
2
1
1 Returns to the Control screen of the previous
source.
2 Calls the Sound Effects Menu. (page 58)
3 Calls the Setup Menu.
4 Allows you to start security code registration.
5 Turns the SI function On or Off.
If turned "On", the burglar alarm lamp flashes
when the vehicle ignition is off. (
• If you have already completed the code registration,
cannot touch
S e t
54
|
English
is not shown,
to display it.
4
5 5
On)
.
2
Start the security code registration
S e t
1
2
1 Enters the numbers to your security code.
2 Clears your entry.
3 Cancels the registration and returns to the
Security Code Setup screen.
4 Registers your security code.
3
Enter the security code
0
Input the four-digit number.
4
Register your security code
5
Reenter the security code
Reenter the same security code as that you have
entered in step 3 for confirmation.
• If you enter an incorrect security code, the screen
returns to step 3 (for the first code entry).
6
Register the security code again
Now, your security code is registered.
If you press the Reset button or if you disconnect
your Receiver from the battery after the code
registration, you need to enter the registered
security code.
See following for details.
3 4
—
9