Installation Procedure 1. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. 2. Make the proper input and output wire connections for each unit. 3. Connect the speaker wires of the wiring harness. 4.
PRK SW Connect to the terminal that is grounded when either the telephone rings or during conversation. To connect the Kenwood navigation system, consult your navigation manual. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna.
Page 5
Rear view FM/AM antenna input REVERSE ILLUMI REMO.CONT MUTE ANT. CONT P CONT EXT.CONT FUSE ( 10A ) Cooling fan Accessory 1 White/Black Gray/Black Green/Black Purple/Black To front left speaker White To front right speaker Gray To rear left speaker Green To rear right speaker Purple...
System Connection USB terminal (iPod) USB terminal iPod Do not connect. DDX8019/DDX8039 USB device (commercially available) USB device (commercially available) Accessory 2 Rear view ■ Audio/Visual input2 • Visual input (Yellow) • Audio left input (White) • Audio right input (Red) ■...
Installing the Escutcheon For General Motors 1. Cut out accessory 4 to meet the shape of the opening of the center console. 2. Attach accessory 4 to the unit. For Volkswagen 1. Attach accessory 8 to the unit. DDX8019/DDX8039 Cut out to meet the shape of the opening in the vehicle.
Page 9
For Toyota/Scion 1. Cut out accessory 4 as illustrated. 2. Fold double-sided adhesive (accessory 5) along the slit and attach it to accessory 4 cut-out against the center rib as illustrated. Use 2 pieces of accessory 5 for 1 accessory 4 cut- out.
Page 10
Installation for Monitor/Player Unit Screw (M4X8) (commercially available) Self-tapping screw (commercially available) Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). Installation on Toyota, Nissan or Mitsubishi Car using Brackets Accessory 6 (M5x6mm) or Accessory 7 (M5x7mm) DDX8019/DDX8039...
Removing Monitor/Player Unit Removing the Hard Rubber Frame (escutcheon) 1. Engage the catch pins on the removal tool 3 and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. Accessory 3 ⁄...