Managing Incoming Calls - Jensen VM9226BT Operating Instructions Manual

10. A prompt to pair or bond should appear on your mobile phone. Accept the
request and initiate the process.
NOTE: Some mobile phones require a "pass key" or pairing code to connect. If your
phone requires a pass key or pairing code, you will need to enter this number. The
default pairing code for many mobile phones is "0000". The default code for the unit
is "1234".
11. A prompt to enter a PIN number or passkey for the unit should appear. The
default passkey for the unit is "1234".
12. At this point a prompt stating pairing successful should appear. Another
prompt should appear asking connect to the unit, Yes or NO. Press Yes. The
mobile phone and the unit should connect. The mobile phone should display
a message similar to "Device Connected" and the mobile phone and the
unit are now connected. VM9226BT will appear on the mobile phone list of
devices.

Managing Incoming Calls

When connected to a Bluetooth® mobile phone, the unit will mute audio output,
pause CD play, and change to the Bluetooth® screen below when a call is received.
The incoming phone number or as-signed name for that number will appear in
the middle of the screen. An audible tone will sound from the unit and a graphic
display will appear on the front panel.
Direct Entry:
1.
screen for further detail.
2. icon: Touch to answer an incoming call.
3. Transfer Call: Touch to transfer a call back to the mobile phone.
4. Mute: Touch to mute the microphone audio from the unit. Touch the icon
again to restore the microphone and audio from the unit.
5. icon: Touch to end an in coming call.
56
Touch to access the direct dial screen. Refer to the Direct Entry
VM9226BT