Assembly Instructions - Impex SA GEAR SAG-71 Owner's Manual

ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine
to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not tighten Nuts and Bolts until instructed to do so.
B.) Attach one Base Frame (#1) to the Rear Base Frame (#10). Secure it with one M10 x
3 1/8" Carriage Bolt (#24), one Ø ¾" Washer (#34), and one M10 Aircraft Nut (#32)
from bottom. Secure it with one M10 x 5/8" Hex Bolt (#30) and one Ø ¾" Washer
(#34) from side.
C.) Attach the Left Rear Support (#8) to the left end of Rear Base Frame. Secure it with
one M10 x 2" Hex Bolt (#27) and one Ø ¾" Washer (#34).
D.) Repeat B & C to install the other Base Frame and the Right Rear Support (#9) to the
Rear Base Frame.
6
DIAGRAM 1