Impex SA GEAR SAG-71 Owner's Manual page 8

STEP 2 (See Diagram 2)
A.) Do not tighten Nuts and Bolts until instructed to do so.
B.) Attach the Left Upright Beam (#2) onto the left Base Frame (#1). Secure it with two
M10 x 3" Hex Bolts (#29), four Ø ¾" Washers (#34), and two M10 Aircraft Nuts (#32).
C.) Attach the bracket on Left Upright Beam to Left Rear Support (#8). Secure it with one
M10 x 2 3/8" Hex Bolt (#28), two Ø ¾" Washers (#34), and one M10 Aircraft Nut (#32).
D.) Repeat B & C to install the Right Upright Beam (#3).
E.) Securely tighten all Nuts and Bolts in Step-1 and Step-2.
7
DIAGRAM 2