Assembly Instruction - Impex MARCY CLASSIC MWM-977 Owner's Manual

ASSEMBLY INSTRUCTION

Tools Required for Assembling the Machine: Two Adjustable Wrenches and
Allen Wrenches. NOTE: It is strongly recommended this machine to be
assembled by two or more people to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Insert the two Guide Rods (#17) into the holes on the Rear Stabilizer (#4). Secure
each Guide Rod with one M10 x ¾" Allen Bolt (#60) and  ¾" Washer (#65) from
the bottom. The Guide Rods has hole on the rod to lock the weight stack
when not in use. The shorter end of the guide rod with the lock hole will
need to be pointed downwards towards the Rear Stabilizer.
B.) Do not tighten all Nuts and Bolts starting from this procedure until instructed
to do so.
C.) Attach the rear of Base Frame (#3) to the Rear Stabilizer. Secure them with two
M10 x 2 ¾" Carriage Bolts (#55), one 2" x 7" U-shaped Bracket (#21), two Ø ¾"
Washers (#65), and two M10 Aircraft Nuts (#69).
D.) Attach the Vertical Frame (#2) onto the Base Frame. Secure them with two M10 x
2 ¾" Carriage Bolts (#55), one 1 ¾" x 4 ¾" (#20), two Ø ¾" Washers (#65), and
two M10 Aircraft Nuts (#69).
5
6