Impex MARCY CLASSIC MWM-977 Owner's Manual page 15

STEP 6 (See Diagram 6)
A.) Attach one Swivel Pulley Bracket (#14) to the open bracket on the back of Vertical
Frame (#2). Secure it with one M10 x 2 ½" Allen Bolt (#57), two Ø ¾" Washers (#65),
and one M10 Aircraft Nut (#69). Do not over tighten the Nut and Bolt. Make sure the
Swivel Pulley Bracket can swivel freely.
B.) Repeat Procedure A to install the other Swivel Pulley Bracket on the other side.
C.) Attach two Butterfly Cable Brackets (#12) to the Right & Left Butterfly (#9 & #10). Secure
each Butterfly Cable Bracket with one M10 x 2" Allen Bolt (#58), two Ø ¾" Washers
(#65), and one M10 Aircraft Nut (#69).
D.) Attach the Leg Developer (#7) to the Leg Developer Holder (#5). Secure it with one Leg
Developer Axle (#40), two M10 x ¾" Allen Bolts (#60), and two Ø ¾" Washers (#65).
E.) Insert two Foam Tubes (#23) halfway through the holes on Leg Developer Holder and
Leg Developer. Push four Foam Rolls (#28) onto the Foam Tubes from both ends.
F.) Attach the Arm Curl Pad (#26) to Arm Curl Stand (#13). Secure it with two M8 x 5/8"
Allen Bolts (#62) and two Ø 5/8" Washers (#66).
G.) Insert the Arm Stand into the opening on the Leg Developer Holder (#5). Use a Lock
Knob (#22) to lock the Arm Curl Stand in position.
14