5 • Installing the Motor Housing
Step 5-1
Step 5-3
Canopy
Screw
Hunter Fan Company
5-1. Place the fan housing over the motor.
5-2. Align the keyholes in the fan housing with the two partially
Motor
installed canopy screws in the hanger bracket. Rotate the fan
housing to situate the screws in the narrow ends of the keyholes.
Fan Housing
5-3. Install the two remaining canopy screws into the holes in the fan
housing and into the hanger bracket. Securely tighten all screws.
5-4. Using both hands, push the canopy trim ring up to the top of the
canopy. The canopy trim ring will snap and lock into place.
Should you need to remove the canopy
trim ring, follow these steps:
1. L ocate the tab indicators, small
bumps on top of tabs.
2. P ress firmly on opposite sides of the
ring towards the canopy. The tabs
will flex out releasing the trim ring
from the canopy.
42824-01 • 03/02/07