Installation - Heath Zenith Motion Sensing Diecast Lantern SL-4190 Series Owner's Manual

Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes,
turn the power off for one minute, then back
on. After the calibration time the control will
be in the AUTO mode.
D B
®
ual rite
Light comes on half bright for selected time af-
ter dusk (Off, 3 hr., 6 hr., until dawn). Selecting
OFF disables this feature. The motion sensing
features will continue to work as described
in this manual. If motion is sensed, the light
turns on full bright for the ON-TIME (1, 5, or
10 minutes) then returns to dim mode.
ON-TIME Switch at 1,
5, or 10 minutes
Flip light
switch off for
one second
then back on*
Dimmer Control

INSTALLATION

For best performance, mount the fixture about
6 feet (1.8 m) above the ground.
WARNING: Turn power off at circuit
breaker or fuse.
1. Remove
two nuts.
3. Tighten screws
finger tight.
5. Attach X-Bar to
junction box
Due to the size and weight of the fixture, you
may find it helpful to have an assistant hold the
fixture in place while connecting the wires.
2
2. Remove
X-Bar.
SENSITIVITY
MIN MAX
4. Set sensitivity on
fixture back to the
mid-position.
Junction
Box
595-5628-08