Final Assembly; Testing And Adjustments - Heath Zenith DualBrite Triple Halogen Motion Sensing Light 5598 Owner's Manual

FinaL asseMBLy

1. Push the wires into the junction box. Make sure
none of the wires get pinched.
2. Slide the fixture assembly onto the mounting screws.
Tighten decorative nuts removed in step 1 of Instal-
lation section securely against fixture base.
Decorative Nut
3. Install one medium base light bulb (100 Watt
maximum).
4. Place top cover onto fixture and attach using
the two decorative nuts (included). Hand tighten
only.
5. After completing the tests on page 5, caulk around
fixture base with silicone weather sealant.
Decorative Nut
Fixture Assembly
Caulk Around
Fixture Base
Mounting Screw
Junction Box
Top Cover
Light Bulb (100
Watt Maximum)

testing anD aDjustMents

1. turn on the circuit breaker and light switch.
Note: Sensor has a 1
before it will detect motion. When first turned on
wait 1 / minutes.
1
2
2. Set:
ON-TIME switch to TEST
SENSITIVITY dial to Midway
TEST 1 5 10
MINUTE
3. Walk through the coverage area noting where you
are when the lights turn on. In TEST mode, light
will stay on for 5 seconds after sensing motion and
then turn off.
4. Adjust the SENSITIVITY to increase or decrease
the range as needed. Too much sensitivity may
cause false triggering due to heat sources in the
coverage area (see Adjustment of Coverage Area
or Troubleshooting section).
5. Set the amount of ON-TIME you want the light
to stay on after motion is detected (1, 5, or 10
minutes).
6 ft.
(1.8 m)
Maximum Range
4
/ minute warm up period
1
2
– +
SEN
30 ft.
(9.1 m)
Maximum
Coverage Angle*
(Top View)
598-1314-00
180°