Catalytic Enamel Surface - Samsung BT62TDBST Installation And Operating Instructions Manual

Cleaning and Care (continued)

Catalytic enamel surface

EN
The removable cover casing is coated with a dark gray catalytic enamel that can become
coated with oil and fat distributed by circulating air during convection heating . These deposits
will burn off at oven temperatures of 200 °C and higher, for example, when baking or roasting .
Higher temperatures will result in faster burning.
The oven and accessories should be cleaned after each use . Otherwise further baking and
roasting will cause the deposits to bake on even harder and cleaning may become difficult and
in extreme cases impossible .
Cleaning by hand
Make sure the oven is cool before cleaning .
● The catalytic enameled cover casing should be cleaned using a solution of hot water and
washing-up liquid applied with a soft nylon brush.
Do not use abrasive cleaning agents, hard brushes, scouring pads or cloths, steel wool, knives
or other abrasive materials . Do not use oven spray on catalytic enamel as the chemicals used
in oven sprays will damage catalytic enamel and render it ineffective .
If using oven sprays on the interior oven surfaces, the catalytic cover casing must first be
removed from the oven .
Cleaning with high temperatures
Before cleaning the catalytic cover casing with high temperatures, make sure that all interior
oven surfaces have been cleaned as described above . Otherwise, the high temperatures
can bake deposits onto the interior oven surfaces and make them impossible to remove .
If, after manual cleaning, the oven is still heavily soiled, heating it to a high temperature will
help remove soiling caused by oil and grease splashes .
Note that deposits of spices, syrups and similar substances are not removed by this process .
These should be removed by hand with a mild solution of hot water and washing-up liquid ap-
plied with a soft brush .
● Remove all accessories from the oven .
● Set the oven to conventional function .
● Set the heat to 250 °C .
● Run the oven for approximately 1 hour . The length of time will depend on the degree of
soiling .
It is a good idea to set the finish time for the process using the end time setting, in case you
forget to switch the oven off at the end .
Any remaining soil will gradually disappear with each subsequent use of the oven at high
temperatures .
38