Additional Clearances To Combustibles; Flooring Requirements - Waterford Ashling Installation & Operating Instructions Manual

Appliance Clearances
No Heat Shields
Flue Collar and
Connector Shield
Double Wall Connector 14-in
Minimum alcove
Width
Maximum alcove
Width
Alcove Ceiling Above
Stove top
Hearth Mount
Chimney Connector
No heat shields
Using Connector Shield
Double Wall Connector
Single Wall Connector
Double Wall Connector
The unit must be placed on non-combustible material extending 2-in (50mm) beyond each side, 2-in (50mm)
beyond the rear, and 2-in (50mm) beyond each side of the chimney connector. If the optional side fuelling
door is used, the floor protection must extend 16-in (410mm) beyond the door. Combustible flooring 16-in
(410mm) beyond the front and 8-in (200mm) beyond each side of the front fuel opening must be protected
by either a listed non-combustible insulative floor protector or a field installed non-combustible insulative floor
protection with an R value of at least 1.2.
For use in Canada, the non-combustible floor protection must be extended to 18-in (460mm) beyond the fire
door(s) and 8-in (200mm) beyond the sides and rear of the stove.

ADDITIONAL CLEARANCES TO COMBUSTIBLES

Unprotected Surfaces
Parallel Corner
Side Rear
16-in 12-in 12-in
405-mm 305-mm 305-mm
14-in 6-in 10-in
355-mm 150-mm 255-mm
6-in 10-in
355-mm 150-mm 255-mm
58-in
1475-mm
48-in
1220-mm
34-in
865-mm
Side Trim Top Trim
7-in 14-in
180-mm 355-mm
Unprotected Surfaces (vert)
12-in
305-mm
6-in
150-mm
6-in
150-mm
Unprotected Surfaces (horiz.)
18-in
460-mm
6-in
150-mm

FLOORING REQUIREMENTS

Protected Surfaces (NFPA - 211)
Parallel
Side
7-in
180-mm
7-in
180-mm
7-in
180-mm
40-in
1015-mm
48-in
1220-mm
12-in
305-mm
Mantle
24-in
610-mm
Protected Surfaces (vert).
Protected Surfaces (horiz.)
8
Corner
Rear
6-in 6-in
150-mm 150-mm
6-in 6-in
150-mm 150-mm
6-in 6-in
150-mm 150-mm
6-in
150-mm
6-in
150-mm
6-in
150-mm
12-in
305-mm
6-in
150-mm