3.
Marvell
Serial ATA 6.0 Gb/s connectors
®
(7-pin SATA_6G_1, 7-pin SATA_6G_2 [gray])
These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA 6.0 Gb/s
hard disk drives.
•
These connectors are set to Standard IDE mode by default. In Standard IDE mode,
you can connect Serial ATA data hard disk drives to these connectors.
•
You must install Windows
hard disk drives.
When using hot-plug and NCQ, set the Marvell(R) SATA6G Controller item in the
•
BIOS to [AHCI Mode]. Refer to section 3.6.3 Onboard Devices Configuration for
details.
ASUS P7H57D-V EVO
®
XP Service Pack 2 or later versions before using Serial ATA
2-31