BKI FKM Installation And Operation Manual page 28

Electric Pressure Fryer
9. Press the desired program number a second time. The red light above the program number will
flash and the computer will display "COOK". This will start a countdown in minutes and seconds
until the end of the cycle.
10. At the end of the cooking cycle, the computer will display "DONE" and signal with a series of
audible "beeps". Press the selected number once again to stop the cook cycle. Fifteen seconds
before the end of the cook cycle, the program will automatically release the pressure from the
fryer. For your safety, the lid will not unlock, even at the end of the cook cycle, until the pressure
has been fully released.
Hot steam will escape when you open the lid possibly causing severe injury.
Keep your face and arms away from the fry pot.
11. Slowly turn the spin handle counterclockwise to break the seal around the lid. Your fryer has a
locking pin that prevents turning the spin handle until the pressure drops to "0".
12. Slowly open the lid.
Failure to use the insulated mitts will result in injury. Always use the insulated
mitts when handling the hot fry basket.
13. Lift the basket and hang it on the front of the fryer pot to drain.
14. Empty the basket.
15. Remember to filter the shortening at least every third frying cycle load. Refer to the procedure in
this manual. Also filter the shortening and clean the fryer at the end of each day.
16. Close the lid and press the 0 button. Idle 255F will display. This will automatically hold the
shortening at a cooler temperature.
17. To escape the idle mode, press the 0 button again and the fryer will heat to its original
temperature.
18. When you have finished frying for the day, turn the FILTER/OFF/FRY switch to the OFF position.
26
Operation