Only Feature - Radio Shack 14 Minute Owner's Manual

± ±
"016'" "
• If memory is full, three
short beeps sound
when you try to record
a memo, 2-way
conversation, or
change the outgoing
<Bý <Bý <Bý <Bý
message. appears
on the display.
• Many local phone
companies use Calling
Party Control (CPC) to
signal that a caller has
hung up. Your system
can recognize a CPC
signal and release the
line.
• The announce-only
outgoing message
does not affect your
original outgoing
message. Each
outgoing message can
be recorded, played
back, or deleted
independently.
• When the system is
set for announce-only,
you cannot record
incoming messages
using remote
commands. You can
use remote commands
to perform all other
operations.
12
on the same line is picked up or
the system detects a Calling Party
Control (CPC) signal, it stops
playing the outgoing message or
recording, and resets to answer
± ± ±
another call.±
5. When the system is off and there is
an incoming call, it will answer the
call after 10 rings and sound a long
beep, then waits seven seconds
for the remote code.
7 " "#
5+0) 6*' 00170%'
1 "(
0.; '#674'
Your system's announce-only feature
lets you play a message for the caller,
then automatically hangs up without
letting the caller leave a message. ±
To select announce-only mode, slide
to
INCOMING MSG ANN ONLY
illustration on Page 9). When the
system receives a call, it plays the
announce-only message, then monitors
the phone line for remote codes
received within about seven seconds.
To turn off the announce-only feature,
slide to
INCOMING MSG ANS
/
±
± ±
(see
.