Advertisement
www.radioshack.com
OWNER'S MANUAL —
Please read before using this equipment.
OGM — Hold down to record
an outgoing message.
PLAY/PAUSE — Press to play
all messages, memos, and 2-
way recordings. Press while
playing to pause.
# # # #
/TIME CHECK — Press to hear
the current day and time.
Press during playback to repeat the
current message. Hold down
during playback to repeat the
previous message.
STOP/ON/OFF — Press to
turn the system on and off,
or during playback to stop.
MEMO — Hold down to
record messages for
yourself or others.
H H H H and G G G G — Adjust message
playback volume higher or
lower.
If an icon appears at the end of a paragraph, go to the box on that page with the
corresponding icon for pertinent information.
Rý Rý Rý Rý
#
— Warning
— Important
©
2002 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
36//KPWVG"&KIKVCN
#PUYGTKPI"5[UVGO
SM
, , , ,
/TIME SET — Press during
playback to skip to the next
message. Hold down while
stopped to enter day/time setting
mode.
DELETE — Press during
playback to delete a
message.
2 WAY — Press to record a
telephone conversation.
#
#
"+/2146#06"
° ° ° °
. . . .
— Caution
— Hint
43-3822
±
±
±
±
— Note
Advertisement
Table of Contents
Related Manuals for Radio Shack 14 Minute
Summary of Contents for Radio Shack 14 Minute
- Page 1 Rý Rý Rý Rý ° ° ° ° ..± ± ± ± — Warning — Important — Caution — Hint — Note © 2002 RadioShack Corporation. All Rights Reserved. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
-
Page 2: Table Of Contents
Your RadioShack 14 Minute Digital %106'065 Answering System is a sophisticated, Read This Before fully digital message center. All Installation ....3 messages are stored on a chip, so Installation ...... 4 there are no tape mechanisms to wear Installing the Backup out and no tapes to bother with. -
Page 3: Answer Calls
Remote Answer-On — Call the system Playing Messages/ Memos/Two-Way Phone from a remote location and set it to Conversations ... 14 answer calls. Deleting Messages ... 15 Remote Operation ..16 Adjustable Ring Number — Set the Operating the System system to answer after two, four, or from a Remote seven rings. -
Page 4: Battery
REN. The REN is on the bottom of the system. If you use more than one phone or other device on the line, add up all the RENs. If the total is more than five (or three in rural areas), your phone might not ring and your TAD might not answer. -
Page 5: Connecting The System To A Phone Line
3. Replace the cover and secure it ± ± ± ± ± ± ± ± $#66'4;"016'5" " with the screw. • Listen to new Beý Beý Beý Beý messages before 4. Replace the battery when replacing the battery, appears on the display. Unplug the since removing the AC adapter and disconnect the battery erases all... -
Page 6: Power
1. Plug the system’s modular phone line cord into the wall jack. 2. Plug your phone’s modular phone line cord (not supplied) into the PHONE JACK "#%"2 100'%6+0) 19'4 ± ± "016'" " Plug the AC adapter into a standard AC •... -
Page 7: On/Off
24'2#4#6+10 ± ± "016'" " • A beep sounds when " "5 " 740+0) ;56'/ you press STOP/ON/ OFF. • You can also turn on To turn on the system, press STOP/ON/ the system remotely. . The number of recorded See “Remote messages appears on the display. -
Page 8: And Time
advance until you set the correct day and time. 1. Turn on the system. , , , , 2. Hold down for about /TIME SET two seconds, then release it. The ' ' ' ' system announces “Monday” and appears on the display. , , , , 3. - Page 9 " " " " '66+0) 07/$'4 " "+ " +0)5 #0& 0%1/+0) '55#)' RING SELECT — Slide to 2, 4, or 7 to select the number of rings you hear before the system answers. Slide to TS to avoid unnecessary charges when calling long distance to check your messages.
-
Page 10: Message
" " '%14&+0) ± ± "016'" " "/ " 76)1+0) '55#)' • The maximum length You can use the system’s prerecorded for an outgoing message is about 60 outgoing message, “Hello, please leave seconds and the a message after the tone”, or record minimum is about 3 your own. -
Page 11: Only Outgoing
3. Release when you are ± ± "016'" " finished. The system automatically plays back your recorded • To hear the announce 7( 7( 7( 7( only outgoing message. appears on the display during the playback. ± ± message, press OGM. ±... -
Page 12: Only Feature
on the same line is picked up or ± ± "016'" " the system detects a Calling Party Control (CPC) signal, it stops • If memory is full, three short beeps sound playing the outgoing message or when you try to record recording, and resets to answer a memo, 2-way ±... - Page 13 "% %4''0+0) #..5 ± ± "016'" " To screen your calls, let the system • When volume is set answer. Listen to the caller’s message to minimum, the through the system’s speaker. If you caller’s message decide to answer the call, pick up any cannot be heard.
- Page 14 " "4/9 " '%14&+0) "+/2146#06" "% *10' 108'45#6+10 Every state has different regulations governing You can record both sides of a the recording of conversation on any phone connected conversations over the to the same phone line as the system. telephone.
- Page 15 2. To replay the messages, press . Press PLAY/PAUSE PLAY/PAUSE F F F F again to pause. appears on the display. Press again PLAY/PAUSE to resume playback. The system returns to answer-ready mode after seven seconds if you do not press again.
- Page 16 To delete all messages after playback, ± ± "016'" " hold down for about two DELETE seconds. The system beeps and all Deleting Messages ± ± ± messages are deleted.± • If you hold down DELETE before playing back all 4'/16'"...
- Page 17 "% '/16' 1//#0&5 RadioShack store for assistance. To locate your nearest RadioShack, use 2TGUU< the store locator feature on RadioShack's website If there are no new messages, you hear three (www.radioshack.com), or...
- Page 18 When you press to play new messages, or to play all messages (during playback), you can then press the following keys to get these remote functions. Erase current message. Repeat previous message. Skip a message. Repeat current message. Stop current message. After all your messages have been played, you hear two short beeps.
- Page 19 this product is a label with this product’s ± ± "016'" " FCC Product Identification number in the format US:AAAEQ##TXXXX . If You must not connect your system to: requested, you must provide this information to the telephone • coin-operated ±...
- Page 20 In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law: (a) correct the defect by product repair without charge for parts and labor;...