Message - Radio Shack 14 Minute Owner's Manual

± ±
"016'" "
• The maximum length
for an outgoing
message is about 60
seconds and the
minimum is about 3
seconds. In the last
7'ý 7'ý 7'ý 7'ý
10 seconds,
flashes rapidly,
indicating recording
will end soon. When
the maximum
outgoing message
length is reached, the
system sounds three
short tones and plays
back the message.
Repeat these steps
to record a new
outgoing message.
• If you record your
own message and
later decide to use
the prerecorded
message, hold down
OGM until a beep
sounds. Release
OGM, and the
system plays the
prerecorded outgoing

message.

10
4 " "
'%14&+0) 6*'
1 "/
76)1+0) '55#)'
You can use the system's prerecorded
outgoing message, "Hello, please leave
a message after the tone", or record
your own.
1. Hold down until
OGM
the display and the system beeps.
Speak clearly into the microphone.
2. Release when you are
OGM
finished. The system automatically
plays back your recorded
7' 7' 7' 7'
message. appears on the
display during the playback. ±
4 " "
'%14&+0) #0
# "1
00170%' 0.;
1 "/
76)1+0) '55#)'
The system has a prerecorded
announce-only outgoing message that
says "No one is available to take your
call". You can use this message or
record your own.
1. Slide
INCOMING MSG
2. Hold down until
OGM
and the system beeps. Speak
clearly into the microphone.
"
7' 7' 7' 7'
appears on
±
± ±
"
to .
ANN ONLY
7( 7( 7( 7(
appears