3D Eyewear - Registration; 3D Eyewear - Replacing Battery - Panasonic TH-P50ST60Z Quick Manual

3D Eyewear - Registration

■
First registration
Perform the first registration when the 3D Eyewear is used for the first time.
1. Turn the TV on
2. Press Power button for about 1 second to turn the 3D Eyewear on
The lamp lights for about 2 seconds and then flashes.
●
The 3D Eyewear will be turned on and the registration will start.
●
Place the 3D Eyewear within 50 cm from the TV while registration in
●
progress.
3. After the registration is successfully completed, the 3D Eyewear will
reconnect with TV automatically when the 3D Eyewear is turned on near
the TV in 3D mode
■
Registration again
When connection with the registered TV fails, or when using with another TV,
re-register the 3D Eyewear.
1. Turn the TV on
2. Within 50 cm from the TV, press Power button until lamp lights, then
release it to start registration
3. After the registration is successfully completed, the 3D Eyewear will
reconnect with TV automatically when the 3D Eyewear is turned on near
the TV in 3D mode
= Note =
If the registration failed, the 3D Eyewear will be turned off. In this case,
●
turn the TV off and perform from step 1.

3D Eyewear - Replacing battery

When the battery is running low, the indicator lamp flashes 5 times on turning
the 3D Eyewear on. In this case, early battery replacement is recommended.
Dispose of the old batteries as non-burnable rubbish, or in line with the
●
waste disposal regulations in your local area.
1. Remove the battery cover using pen tip or screwdriver (minus -) etc.
- 38 -