3D Eyewear - Functions - Panasonic TH-P50ST60Z Quick Manual

Do not exert pressure on or scratch the lens of the 3D Eyewear.
●
3D content will not be correctly visible if the 3D Eyewear is worn upside
●
down or back-to-front.
When viewing 3D images, make sure your eyes are at an approximately
●
horizontal level and keep a position where you do not see double images.
Do not wear the 3D Eyewear when watching something other than 3D
●
images. Liquid crystal displays (such as computer screens, digital clocks
or calculators, etc.) may be difficult to see while wearing the 3D Eyewear.
Do not use the 3D Eyewear as sunglasses.
●
3D effects may be perceived differently depending on the person.
●

3D Eyewear - Functions

■
Part names and functions
Power button / Mode change / Indicator lamp
Power button
●
– Press and hold for approx. 1 second to turn the 3D Eyewear On.
(The indicator lamp lights for 2 seconds.)
– Press and hold for approx. 2 seconds to turn the 3D Eyewear Off.
(The indicator lamp lights 3 times.)
Mode change
●
– Press and hold for approx. 1 second to change the mode between
3D and 2D (view a 3D image in 2D).
– When power is off, press and hold for approx. 5 seconds to change
to registration mode.
Watching
Indicator lamp
●
– Lights or flashes during use to show the status (see below).
Protection film
– Peel off the protection film on both side of the lens.
Insulating sheet
Battery cover
– When using for the first time, remove the insulating sheet. Pull the
3D 3D Eyewear - Registration
- 36 -