Table of Contents
Advertisement
1.
Hard disk installation of replacement
A.
Hard disk installation
After shutting down the DVR, unplug the power from the outlet.
① Loosen the screw on the left, right and rear side of the DVR casing.
② Separate the cover of the main unit.
③ Remove the screws on the bracket holding
the hard disk. Then, separate the bracket
from the hard disk.
④ Install the hard disk to the bracket and tighten the 4 screws.
▶ Connecting bracket to hard disk
Orient the SATA cable connection
port towards the base of the hard
disk bracket, and secure the HDD in
place.
Connect the bracket to hard disk by
tighten the 4 screws
⑤ After installing the bracket on the main unit, tighten the screws.
⑥ Connect the power cable of the hard disk.
⑦ Connect the SATA cable to the hard disk.
[Connecting power cable]
⑧ Connect the SATA cable to the SATA port of the main board.
⑨ Close the cover of the main unit.
[Connecting SATA cable]
14
U
'
M
SER
S
ANUAL
H.264 R
T
DVR
EAL
IME
Advertisement
Table of Contents
