The Routing Table Page - Zoom 3G+ Modem/Router User Manual

Enter the IP address for WAN access. The default value of 0.0.0.0 indicates
that every IP address can get some information about this device, using the
SNMP protocol.

The Routing Table Page

You can use the Routing Table page to enable/disable both Dynamic and Static
Routing. If routing is enabled, you can specify which physical interface address to
use for outgoing IP data grams. If you have more than one Modem/Router and subnet,
you will need to define a routing table that lets packets find the proper routing path
and allows different subnets to communicate with each other. Most users do not need
to set up Dynamic or Static Routing.
Dynamic Routing
The Routing Information Protocol (RIP) will exchange information about
destinations for computing routes throughout the network. Please select
RIPv2 only if you have different subnet in your network. Otherwise, please
select RIPv1 if you need this protocol.
Static Routing
For static routing, you can specify up to eight routing rules. You can enter
the Destination IP address, Subnet Mask, Gateway, Hop for each routing
rule. Click the Enable checkbox to activate the routing table entry.
80 3G+ Modem/Router with Wireless-N and Phone Port User Manual