Facing Material; D. Finishing Material - Heat & Glo LCOR-36TRB-IPI Owner's Manual

TOP VIEW
FIREPLACE
2-3/4
OPENING
in. Min.
3-1/4 in. Min.
Note: Clearance from opening to perpendicular wall.
Figure 13.16 Combustible Mantel Leg or Wall Projections
(Acceptable on both sides of opening)
C. Facing Material
• Metal front faces may be covered with non-combustible
materials only.
• Facing and/or fi nishing materials must not interfere with
air fl ow through louvers, operation of louvers or doors,
or access for service.
• Facing and/or fi nishing materials must never overhang
into the glass opening.
• Observe all clearances when applying combustible
materials.
• Seal joints between the fi nished wall and appliance top
and sides using a 300 °F minimum sealant. Refer to
Figure 13.17.
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specifi ed in
this manual. Overlapping materials could ignite and will
interfere with proper operation of doors and louvers.
Finish wall material may be
combustible - Top and Sides
0 in.
High Temperature Sealant (300° F/149° C min.)
Top and Side Seal Joint
Figure 13.17 Noncombustible Facing Diagram
58 Heat & Glo • ST-36TRB-IPI, PIER-36TRB-IPI, LCOR-36TRB-IPI, RCOR-36TRB-IPI • 2128-900 Rev. B • 10/08
1/2 in.
Min.
Unlimited
1 in.
Max.
0 in.
0 in.

D. Finishing Material

Only doors certifi ed for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and fi nishing material is going to be used on the fi replace,
you may use the table below which shows the door mod-
els and the fi nishing material thickness allowed. For an
inside fi t there is an available template to assist with siz-
ing the fi nishing material.
ST-36TRB-IPI
DOOR FIT
Aero Inside
Folio Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
Valencia
Inside
Overlap
Galleria
Inside
PIER-36TRB-IPI
DOOR FIT
Aero Inside
Chateau Inside
Arcadia Inside
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
Stop fi nishing material fl ush with opening.
Figure 13.18 Folio Door and Aero
FRONT FACE OF FIREPLACE
DOOR
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
Figure 13.19 Overlap Fit Door
FINISH MATERIAL
MAXIMUM SEE FIGURE
THICKNESS
Any 13.18
Any 13.18
1 inch 13.19
Any 13.20
1 inch 13.19
1 inch - 2 inch 13.21
1 inch 13.19
Any 13.20
1 inch 13.19
Any 13.20
1 inch 13.19
1 inch - 2 inch 13.21
FINISH MATERIAL
MAXIMUM SEE FIGURE
THICKNESS
Any 13.22
Any 13.22
Any 13.22
DOOR
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
1 in. MAX
FINISHING MATERIAL
(TOP EDGE)