Lighting Instructions - Heat & Glo GRL-700-AU Installation And Operation Instructions Manual

Hearth and home technologies gas log sets manual grl-700-au
Table of Contents

Advertisement

LIGHTING INSTRUCTIONS

1. "STOP!" Read the safety information on previous
page.
2. Remove the control access cover.
3. Turn the valve control knob to the "OFF" position.
To do this, you must turn the knob
clockwise
then press in and continue turning
clockwise
GAS CONTROL VALVE
NOTE: Knob cannot be turned from "PILOT" to
"OFF" unless knob is pushed in slightly. Do not
force.
4. WAIT FIVE (5) MINUTES TO CLEAR OUT ANY
GAS. Then smell for gas, including near the
floor. If you then smell gas, STOP! Follow "B"
in the safety information on the previous page.
If you don't smell gas, go to the next step.
5. The pilot should not require accessing for lighting
purposes. The pilot is located at the left end of
the burner.
1. Remove the control access cover.
2. Turn ON/OFF switch to "OFF".
LIGHTING INSTRUCTIONS
to the "Pilot" position, and
to the "OFF" position.
TO TURN OFF GAS APPLIANCE
PILOT ASSEMBLY
6. To put the control in the "Pilot" position, turn the
control knob counter-clockwise
"Pilot" position.
7. To light the pilot depress the control knob and then
depress the red piezo button until it makes a
clicking sound. It may be necessary to repeat this
step. If the pilot does not light after 10 seconds, go
back to step 3. The control knob should be held in
for a MINUTE after pilot ignition.
• If the control knob does not pop out when re-
leased, STOP-shut off the gas supply to the fire-
place control valve, and IMMEDIATELY call your
service technician or gas supplier.
• If the pilot will not stay lit after two tries, turn the
control knob to the "OFF" position and call your
service technician or gas supplier.
8. After the pilot has been lit, the burner can be turned
on by turning the knob counter-clockwise
to the "ON" position. Flip the ON/OFF
switch to the "ON" position.
9. Replace control access cover.
3. Turn the valve control knob clockwise
the "Pilot" position, then depress knob and
continue turning to "OFF" position.
4. Replace control access cover.
12
to the
to

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents