Operating Guidelines And Maintenance Instructions - Heat & Glo GRL-700-AU Installation And Operation Instructions Manual

Hearth and home technologies gas log sets manual grl-700-au
Table of Contents

Advertisement

3.0
OPERATING GUIDELINES AND
MAINTENANCE INSTRUCTIONS
Upon completing the gas line connection, a small
amount of air will be in the lines. When first lighting the
pilot light, it will take a few minutes for the lines to
purge themselves of this air. Once the purging is com-
plete, the pilot and burner will light and operate as indi-
cated in the instruction manual. Subsequent lighting of
the appliance will not require such purging.
WARNING: BE SURE FIREPLACE SCREEN
!
OR GLASS DOORS ARE IN PLACE WHEN
BURNING FIREPLACE LOGS. UNLESS OTHER
PROVISIONS FOR COMBUSTION AIR ARE PRO-
VIDED, THE SCREEN OR DOORS SHALL HAVE
AN OPENING FOR INTRODUCTION OF COM-
BUSTION AIR. THIS GAS LOG SET IS NOT DE-
SIGNED TO OPERATE WITH AIR TIGHT GLASS
DOORS. IF GAS ODOR IS NOTICEABLE, TURN
CONTROL KNOB TO "OFF" POSITION AND
CHECK ALL CONNECTIONS FOR LEAKS. DO
NOT USE OPEN FLAME. ADEQUATE COMBUS-
TION AND COOLING AIR MUST BE PROVIDED
OR THE UNIT WILL NOT FUNCTION PROPERLY.
The following conditions must not cause spillage of
combustion products:
• cold chimney or flue system
• open or closed doors or windows
• operation of any exhaust or extraction fans
• operation of any other gas appliance in the room or
dwelling
Proper means must be employed to ensure sufficient
draft.
Note to Installer: Disconnect this appliance and advise
owner if any spillage or abnormal operation occurs which
can't be rechecked immediately.
To obtain proper operation, it is imperative that the pilot
and main burner flame characteristics are steady, not
lifting or floating.
PILOT
FLAME
Figure 3
The thermocouple should be engulfed in the pilot flame (see
Figure 3).
Periodically examine the area around the burner neck and
the pilot. Any dirt or lint in this area should be removed.
This will ensure long life and trouble free operation. When
the appliance is put back in service, check the burner flame
patterns.
The appliance and venting system should be inspected
before initial use and inspected and cleaned at least annu-
ally by an authorized field service person.
10
THERMOCOUPLE

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents