Heat & Glo CERONA-42 Owner's Manual page 34

Note TO APPLIANCE INSTALLERS:
To protect appliance after installation, but before use,
please replace corrugated splatterguard on unit per
directions noted below.
STEP 1
For Cerona-36, center left to right over glass and fold top
center section under top heat shield as in fi gure 1. For
Cerona-42, center left to right over glass and fold top three
center sections under top heat shield.
Figure 1.
STEP 2
On the Cerona-36 model, place outside tabs over top heat
shield and behind arched opening. For Cerona-42, place
outer left and right tabs over top heat shield and behind
arched opening. Figure 2 illustrates placement of outer
center section and outer tabs over and under top heat
shield on Cerona-42. The splatter guard must be inserted
until tabs are engaged behind arched steel opening for
both models.
Figure 2.
34 Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08
STEP 3
Push in folded bottom tab over control module heat shield,
placing lower outside notches on glass support brackets.
See Figure 3 and 4.
Figure 3.
Figure 4.