Planar PT1510MX User Manual page 15

Connecting the Display (Figure 11.1, 11.2)
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the DC power cord to the power connector on the monitor; plug
one end of the AC power cord into the power adapter, and the other end
into an electrical outlet (11.1 ).
3. Connect the VGA signal cable from the display's VGA input connector to
the 15-pin connector of your host computer and tighten the screws
(11.1 ).
4. Connect the Audio-In cable from the audio input port of your display to
the Audio-out port of your computer (11.1 ).
5. Configure the touch screen. Refer to the "Touch Screen Driver
Installation section on page 21.
6. Once the touch screen is configured, monitor is ready for use.
To ensure the LCD display works well with your computer, please
configure the display mode of your graphics card to make it less
than or equal to 1024 x 768 resolution and make sure the timing of
the display mode is compatible with the LCD display.
We have listed the compatible "Video Modes" of your LCD display
in the appendix for your reference.
11