Doors - Heat & Glo 6000GLX-IPI-R Owner's Manual

C. Doors
Only doors certifi ed for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and fi nishing material is going to be used on the fi replace,
you may use the table below which shows the door mod-
els and the fi nishing material thickness allowed. For an
inside fi t there is an available template to assist with siz-
ing the fi nishing material.
DOOR FIT
Folio Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
Valencia
Inside
Overlap
Galleria
Inside
Stop fi nishing material fl ush with opening.
Figure 13.4 Folio Door
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
Figure 13.5 Overlap Fit Door
FINISH
MATERIAL SEE
MAXIMUM FIGURE
THICKNESS
Any 13.4
1 inch 13.5
Any 13.6
1 inch 13.5
1 inch - 3 inch 13.7
1 inch 13.5
Any 13.6
1 inch 13.5
Any 13.6
1 inch 13.5
1 inch - 3 inch 13.7
ELBOW
HEAT
SHIELD
Heat & Glo • 6000GLX-IPI-S/-R, 6000GLX-IPILP-S/-R • 2101-900 Rev. S • 12/08
ELBOW
HEAT
FINISHING
SHIELD
MATERIAL
DOOR
(Outside door width)
37-1/4 in.
(Includes 1/8 in. opening each side of door)
37 in.
(Outside door width)
37-1/4 in.
(Includes 1/8 in. opening each side of door)
Finishing materials over 1 inch thick.
Figure 13.6 Inside fi t door
1-2 IN. THICK
FINISHING
MATERIAL
*IF FINISHING MATERIAL IS THICKER THAN
2 IN., DOORS WILL ONLY OPEN
AS FAR AS PICTURED

DOORS

37 1/4 IN.
Finishing material between 1 and 3 inches thick.
Figure 13.7 Operable hinge door
FINISHING
MATERIAL
37 in.
33-3/4 in.
34 in.
1-2 IN. THICK
FINISHING
MATERIAL
51