Cisco Small Business AP541N Quick Start Manual page 7

• If you are not using DHCP on your network, click Change IP
Address to set the Connection Type on the access point to
Static and change the Static IP Address and Subnet Mask to an
IP address and subnet mask that matches the IP addressing
scheme in your network, so an unknown IP address is not
assigned to the access point.
When you click Apply, you will lose connectivity. You can
reconnect by using the new IP address and password.
• Click Upgrade Software to update the Cisco AP541N with the
latest version of the software.
These tasks can be accomplished by using the procedures in the
Cisco Small Business AP541N Access Point Administration
Guide.
If the access point is connected to the network, the
C
AUTION
Cisco AP541N has not been set to use a static IP address,
and there is a DHCP server on the network, a new IP address
will be assigned to the access point. To modify the
configuration you must discover the IP address assigned to
the Cisco AP541N by using the DHCP server.
We recommend that you return your PC to its original settings.
N
OTE
3
Display the Configuration
Utility by Using CCA
Use Cisco Configuration Assistant 2. 1 or higher (CCA) to configure the
access point when it is deployed in a Cisco Smart Business
Communications System (SBCS) network with a UC520 or SR520.
This procedure assumes you are familiar with CCA. You can find additional
information about CCA at
ps7287/tsd_products_support_series_home.html
6 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
http://www.cisco.com/en/US/products/