Installing The Cisco Ap541N; Factory Default Settings - Cisco Small Business AP541N Quick Start Manual

4
Returning the Cisco Small
Business AP541N to the

Factory Default Settings

To use the Reset
following:
• To reboot the access point, press the
seconds.
• To restore the access point to the factory default settings:
1. Disconnect the access point from the network or disable all DHCP
servers on your network.
2. With the power on, press-and-hold the
10 seconds.
5

Installing the Cisco AP541N

The access point can be placed on a wall, a flat surface, or a ceiling. A
ceiling mount kit is available for this device (AP540N-CMK). Do not deploy
the device in a location where any of the following conditions exist:
High Ambient Temperature—The ambient temperature must not
exceed 104 degrees Fahrenheit (40C).
Reduced Air Flow—The air flow must be adequate to prevent
overheating.
Mechanical Overloading—The device should be level, stable, and
secure to avoid it sliding or shifting out of position.
Circuit Overloading—Adding the device to the power outlet or a PoE
port must not overload that circuit or PoE device.
We recommend using Cat5e or better cable. Also, do not
N
OTE
exceed the maximum cabling distance of 328 feet (100 meters).
10 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
button to reboot or reset the access point, do the
Reset button for less than 10
Reset button for more than