Connecting The Equipment; Verifying The Hardware Installation - Cisco Small Business AP541N Quick Start Manual

6

Connecting the Equipment

This section describes the process for connecting the device to power
and the network.
Attach the power cord to the power connector and outlet (if used).
S 1
TEP
Connect a network Ethernet cable to the access point Ethernet
S 2
TEP
port.
Connect the other end of the Ethernet cable to your network or the
S 3
TEP
Ethernet port of the PC you are using to configure the access point.
DHCP is enabled by default. If a DHCP server is running on
C
AUTION
your network and you have not turned DHCP off, the device
will accept a new IP address when it is connected to your
network. You must use this IP address to configure the
device.
7
Verifying the Hardware
Installation
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the LED states, as described in the
Cisco AP 541N"
If you need help resolving a problem, visit the Cisco Small
N
OTE
Business Support Community at
smallbizsupport. For technical documentation and other links, see
Where to Go From Here, page
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
section.
"Getting to Know the
www.cisco.com/go/
14.
13