Fitting The Cutting Head; Service Position For The Cutting Unit; Placing In The Service Position - Husqvarna P520 D Operator's Manual

Fitting the cutting head

1 Insert the bolts for the link joints and the pins on both
sides.
2 Start the engine and raise the cutting unit to the max
position.
3 Turn off the motor.
4 Fit the pins on both sides.
5 Fit the universal drive shaft.
6 Check the universal drive shaft has enough lubricant.
7 Check and adjust the tilt angle of the cutting unit.

Service position for the cutting unit

The cutting head can be placed in the service position to
provide easy access for cleaning, repairs and servicing. In the
service position the cutting unit is raised and locked in the
vertical position.

Placing in the service position

1 Position the machine on flat ground. Apply the parking
brake.
2 Lower the cutting unit to the float position
3 Turn off the motor.
4 Remove the service hatch.
Maintenance
5 Loosen the two quick connectors on the universal drive
shaft and remove the universal drive shaft.
!
6 Start the engine and raise the cutting unit until it is slightly
off the ground.
7 Turn off the motor.
8 Remove the pins on both sides.
9 Start the engine and raise the cutting unit to the max
position.
10 Turn off the motor.
11 Lift the front edge of the unit and tilt the cutting unit
upward.
12 Secure the cutting unit with the pin in the anchor point.
13 The cutting unit is in the service position
WARNING! Never leave the universal drive
shaft of the machine with one end loose. If
the engine is started, damage can occur.
– 27
English