Chain And Guide Bar Combination - Echo CS-400F Instruction Manual

CHAIN AND GUIDE BAR COMBINATION

Length
mm (in.)
406 (16)
457 (18)
WARNING
Use of replacement saw chain and/or guide bar other than that specified, or operation without the "tip guard" in place,
may cause severe kickback resulting in serious injury.
Only use saw chain designated as, "LOw-KICKBACK," that meets the ANSI B175.1 Standard when tested on the
representative sample of chain saws below 3.8 C.I.D., and the Echo guide bar specified.
IMPORTANT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.
IMPORTANT
If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the name of the
Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at www.echo-usa.com.
Refer to your Chain Saw Safety Manual for kick guard application information.
GUIDE BAR
(Low-kickback)
Replacement guide bars.
The following guide bars may be considered to
have equivalent kickback energy.
• Sprocket nose guide bars of the same length and
nose radius, same pitch and having the same
number of teeth.
• Hard nose guide bars of the same length and
nose radius as a sprocket nose bar.
The following combinations are recommended for model CS-400F.
Guide Bar
ECHO Part No.
Low-kickback
16A0CD3757
18A0CD3762
Pitch
mm (in.)
9.53 (3/8)
9.53 (3/8)
SAW CHAIN
(Low-kickback)
CAUTION
Do not use replacement saw chain unless it has
been designated as meeting the ANSI B175.1
kickback performance requirements, when
tested on the representative sample of chain
saws below 3.8 c.i.d. specified in ANSI B175.1.
NOTE
LOw KICKBACK SAw CHAIN meets the
kickback performance requirements of ANSI
B175.1 (safety requirements for gasoline-
powered chain saws).
23
Saw Chain
Type Links
91vG, 91PX
91vG, 91PX
57
62
CS-400F