Table of Contents
Advertisement
OPERATION
Keep in mind that the wood is heavy and that it will bend and pinch the saw
if improperly supported. The trunk will weaken at the point where you make
the cut unless the tree is lying on perfectly flat ground or supported as
shown. If you make the cut with the tree on the ground, don't let the saw's
chain dig into the earth; it is harmful for the saw, and you stand a good
chance of being struck by flying debris.
To cut the trunk, use the bucking and two-cut sequence shown. The first cut
should be no deeper than one-third the trunk diameter.
Guide Bar and Chain Combination
The following combinations are recommended for model CS-2511TN.
Guide Bar
Length
ECHO Part No.
mm (in.)
305 (12)
12A4CD3251C
356 (14)
14A4CD3259C
Use of replacement saw chain and/or guide bar other than that
specified may cause severe kickback resulting in serious injury.
Chain and guide bar gauge size must be identical.
Guide Bar
(Low-kickback)
Replacement guide bars.
The following guide bars may be considered to have equivalent kickback
energy.
• Sprocket nose guide bars of the same length and nose radius, same pitch
and having the same number of teeth.
• Hard nose guide bars of the same length and nose radius as a sprocket
nose bar.
42
Saw Chain
Pitch (in.)
0.325
80TXL51CQ
0.325
80TXL59CQ
© 11/22 ECHO Incorporated
CS-2511TN
Type
Links
51
59
X7503334400
Advertisement
Table of Contents
