Operating Instructions Belt Changing And Agitator Cleaning; Agitator Assembly - Kenmore 116.22175C Owner's Manual

PIÈCES ET CARACTÉRISTIQUES
Il est important de connaître les pièces et les caractéristiques de l'aspirateur pour l'utiliser correctement et en
toute sécurité. Lire cette section avant de l'utiliser.
Objet Pièce Nº.
aux Etats-Unis
Ampoule 20-5240
Courroie 20-5201
Porte-cordon
Tube
supérieur
Pivot de
rallonge
Porte-cordon
Collet
Pedale de
relâche de
la rallonge
Numéros de
modèle/série
Power-Mate ®
(Au bas)
Pédale de
relâchement
de manche
Pédale de
hauteur de poils
Pièce Nº.
au Canadá
20-40600
20-40979
Porte-fiche
Relâche
rapide
Tube
supérieur
Cordon électrique
Power-Mate ®
Courroie Power-Mate
®
Éclairage
Indicateur de
hauteur de poils
Protecteur de
surchage
Bouton de remise
en circuit
Nettoyeur de bords
(Non illustré)
4
BELT CHANGING AND AGITATOR CLEANING
TO REMOVE BELT
1. Turn Power-
®
Mate upside
down.
2. Unscrew the
two (2) Power-
®
Mate cover
screws.
3. Turn Power-
®
Mate right
side up. Press
handle release
pedal and lower
the swivel. Lift
rear latches up.
4. To remove cover,
grasp the sides and
pull out.
5. Depress
Tabs
tabs on rear of
agitator cover
and rotate
forward to
release from
Agitator
the Power-
Cover
®
Mate base.
6. Lift agitator
assembly out
and remove
worn belt.
Base
End Cap
7. Check and clean end cap areas. See
AGITATOR ASSEMBLY for picture of
complete agitator assembly.
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is changed.
The agitator must also be cleaned according
to the following schedule:
Vacuum Cleaner Use Clean Agitator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
LIGHT - every 2 months
(used 1 time/week)
IMPORTANT
Disconnect vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
®
Power-Mate agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator or end caps.

AGITATOR ASSEMBLY

Belt Pulley
End Cap
End
Cap
Brush Unit
17