Interface Settings; Hexadecimal Dump Mode - Sharp MX-M350U Operation Manual

DESCRIPTION OF SETTINGS

■ Interface settings

These settings are used to control data transmitted to
the USB port or network port of this printer.
The following items can be configured in the "Interface
settings"
● Hexadecimal dump mode
● I/O timeout
● Enable USB port
● USB port emulation switching
● Enable network port
● Network port emulation switching
● Port switching method

Hexadecimal dump mode

This setting is used to output the print data from a
computer in the hexadecimal dump format with
corresponding characters (ASCII). This setting is used
to check proper transmission of print data from the
computer to the printer.
Output example of hexadecimal dump mode
I/O timeout
This setting is used to set the length of time to wait for
an I/O to complete a job on the USB port or the network
port. If the data stream to the port does not transmit
data for a length of time exceeding the timeout, the job
will cancel and the next job will start processing.
The I/O timeout setting is used to set the amount of time
after which an I/O timeout will occur when waiting for
print data.
Default setting: 20 seconds
NOTE
The allowable range of the time is 1 to 999 seconds.
Enable USB port
This setting is used to enable or disable printing from
the USB port.
Default setting: Enable
USB port emulation switching
If the machine is connected using the USB port, select
the emulated printer language.
Setting items Description
Auto The printer language will switch
automatically in accordance with the
data from the computer.
PostScript PostScript emulation is used to print
the data from the computer. (An
optional
needed.)
PCL PCL emulation is used to print the
data from the computer.
NOTE
It is recommended to set "AUTO" (default setting)
unless an error due to this setting occurs frequently.
Enable network port
This setting is used to enable or disable printing from
the network port.
Default setting: Enable
Network port emulation switching
This setting is used to specify a printer language to
emulate when the printer is connected to a computer
through the network port.
The setting items are the same as those of "USB port
emulation switching".
NOTE
It is recommended to set "AUTO" (default setting)
unless an error due to this setting occurs frequently.
Port switching method
The machine can use the two ports shown below for
printing. This setting is used to select when switching
between ports will take place. "SWITCH AT END OF
JOB" or "SWITCH AFTER I/O TIMEOUT" can be
selected. When "SWITCH AT END OF JOB" is
selected, the port will be automatically selected after
each print job is completed. When "SWITCH AFTER I/
O TIMEOUT" is selected, the port will be automatically
selected if the time set in the I/O Timeout setting
elapses.
● USB port
● Network port
8-6
PS3 expansion kit is